canon imageclass mf733cdw flashing light

If the lamp on the ink tank is flashing, ink may have run out. If the lamp on the ink tank is not lit, the ink tank may not be installed properly. Remove the jammed paper, reload paper properly in the printer, then press the RESUME/CANCEL button on the printer. If opening the Paper Output Tray does not resolve the problem, or if the tray was open to begin with, the paper may be jammed. If the Paper Output Tray is closed, open it. Reload paper in the Rear Tray or Cassette and press the RESUME / CANCEL button on the printer. Count the Alarm light flashes on your printer and take the appropriate action to correct the error described below.

The number of flashes indicates the type of error that has occurred. (A) Notes the number of flashes, and (B) represents flashes repeatedly.

When you have successfully disabled the status monitor, you will no longer get reports of empty cartridges when they still contain ink.When a printer error occurs, the Alarm lamp flashes orange as shown below.

If you have the status monitor open on your screen, you should see yellow exclaimation marks (status monitor thinks there is a problem) change to red crosses (status monitor off), like this: The printer will usually beep to acknowledge, but this varies from model to model.ĭepending on your printer model, you may need to turn it off and on again for this to be registered, and you may also need to repeat the process for each cartridge. The symbol is always the same though, it's a red circle enclosing an inverted triangle:Īll you need to do is to hold this button down for 5-10 seconds. First, locate the button that will do this - it's on the front panel of the printer and may be marked 'STOP', 'RESUME', 'CLEAR', 'RESET' or any combination of these. The easiest fix is to turn off the status monitor. Older models have a numeric error report, you may see the error codes U162, U163, E005, or 1401 - there are others, this advice refers to any error that your manual informs you is related to ink levels. You may see a graphic representation on your screen that looks something like this: This can sometimes prevent printing altogether. The Canon status monitor is unusually difficult to work with, and will often report cartridges as empty or low on ink when they have just been replaced. Inkjet printers do not contain any mechanism to measure the amount of ink left in a cartridge - any values that the printer or status monitor give you are estimates based the number of pages printed since the cartridge was last changed.

Canon imageclass mf733cdw flashing light